Sidekick III Faceplate installation Instructions #2

We have created a diagram to show how you can install the Sidekick III faceplate on your cell phone.

A total of 4 pieces are include in the Sidekick III faceplate set.
(back plates #1, front plate #2, track ball side #3, button side #4)
Follow these step to install the faceplate on your Sidekick III phone.

1. Take out back plate(1) and button side(4) “diagram #1”
2. Place button side(4) to the back plate(1) “diagram #2”
3. Slide Sidekick phone into case. Make sure you press phone all the way down into case. “diagram 3”
4. Then start with one side of the track ball side(3) You must press down hard until one side of it lock down. Then proceed to lock down other side of track ball piece(3). You must press very hard to lock in other side. This is the most difficult part of the installation, but remember to press down hard. "diagram #4"
5. Snap on front plate(2)
6. After front screen and plates are installed, you may need to guide the front when opening your sidekick. After use it will become easier to flip open.

Once it is on, this faceplate is very secure. If you need to remove plates: first, get a flat head screw driver and push up on each side pieces, then pop off the back plate.







Diagram #1





Diagram #2






Diagram #3






Diagram #4